LED Flasher using NE555

LED Flasher circuit using NE555 timer IC

LED flasher

 

  • R1, R2, C1 and the supply voltage determine the flash rate. For a variable flash rate, replace R1 with a 1 MΩ pot in series with a 22k resistor.
  • The purpose of R3 and R4 is to limit current through the LEDs to the maximum they can handle (usually 20 milliamps). 470 ohms works well with a supply voltage of 9-12 volts.
  • The duty cycle of the circuit (the percentage of the time LED 1 is on to the time it is off during each cycle) is deterimed by the ratio of R1 to R2. If the value of R1 is low in relationship to R2, the duty cycle will be near 50 percent.
  • The NE555 timer chip can be damaged by reverse polarity voltage being applied to it. You can make the circuit fool proof by placing a diode in series with the supply leads.

 

 

Leave a Reply

This site uses Akismet to reduce spam. Learn how your comment data is processed.